Learn · Hardware
Where a quantum job physically runs
On a superconducting-qubit backend, the circuit you submit is turned into microwave pulses at room temperature. They travel down cables through the stages of a dilution refrigerator to a chip held near ten millikelvin, and the measurement signal travels back up. The figure follows one job along that path.
Why so cold, and why so many stages
Superconducting qubits store their state in tiny microwave excitations, so heat and stray microwaves would scramble it. Each plate is colder than the one above, and every cable is anchored and attenuated at each plate so that warmth and noise from room temperature are removed step by step before reaching the chip. On the way back, the measurement signal is very weak, which is why it passes an isolator and is amplified at 4 K before it leaves the cold.
What this means for a job you send through Q-Bridge
Q-Bridge submits your circuit to the provider you choose; the provider compiles it for its own hardware and runs it there. The physical path differs by technology: superconducting machines look like this figure, while trapped-ion and neutral-atom machines use lasers and vacuum systems instead. Shots, queue times and noise all come from that physical system, which is why results differ between backends.